Picatinny Ring Mount | 34 mm | Quick Release

This assembly is anodised. Anodising creates a protective oxide layer on the aluminium surface, which provides good corrosion protection and a durable finish. Anodised products can withstand daily use and are resistant to scratches and wear.

Hard anodising (Type III) provides a thicker and harder layer than standard anodising and is typically used on products exposed to extra heavy wear.

Installation is simple. The rings are attached to the picatinny rail, and the scope is placed in the lower ring halves, after which the upper halves are tightened.

Manufacturer's recommendation:
• Torque for ring screws (top, M3.5): 1.8–2.0 Nm
• Torque for mounting to rail (M4): 2.0–2.5 Nm
• Make sure the scope is level and has correct eye relief before final tightening

A torque wrench is necessary for correct installation. Overtightening can damage the scope tube.

Scope mounting: Read the guide here

This mount is made from 7075-T6 aluminum – the same alloy used in military equipment, aircraft structures, and high-end climbing gear. 7075-T6 has a strength-to-weight ratio almost twice that of steel and is the preferred material for many professional shooters.

For the vast majority of hunters and shooters, 7075-T6 aluminum is at least as good as steel. The material is lighter, does not corrode, and will withstand decades of use under normal conditions.

Rusan is a Croatian manufacturer with over 30 years of experience in precision rifle mounts. All products are manufactured in-house on modern CNC machines from solid material – without casting or metal injection. Rusan is known for tight tolerances, high repeatability, and an exceptionally wide range of rings, mounts, and adapters for night optics.

Read more about Rusan here: Rusan

See all products from Rusan: Rusan collection

The mounting height of rings is typically given as BH (Base Height) — measured from the top of the Picatinny rail to the bottom of the scope tube (the saddle).

When calculating the total height (Center Height), you should add the scope tube's radius to the BH measurement. For a 30 mm tube, the radius is 15 mm. For a 34 mm tube, the radius is 17 mm.

Formula: Center Height = BH + r

Remember that the Picatinny rail itself raises the mounting point (typically 5-10 mm depending on the rifle model). This means you can often choose a lower ring than you would otherwise need.

Rule of thumb: Choose the lowest ring height that still allows free passage between the scope's objective and the barrel. A lower mount provides better balance and a more natural sight picture.

These rings have an internal diameter of 34 mm and fit scopes with 34 mm tubes. 34 mm is typically used on high-end scopes with a large adjustment range.

Always check your scope's tube diameter before purchase - it can be found in the scope's specifications or easily checked with a caliper.